February 7, 2012

Painting continues while I work on the plenum.  I may be getting a  break from sanding and priming for paint, but I am still sanding and thinking it will never end.

The plenum is finally fitting down where I want it.  All that is the result of cutting re-molding and sanding.

One of the more difficult areas is the from of the engine.  The fit is good, but will still need to be sealed with RTV.

As it turned out with the new center piece of the plenum, it still rested on the fuel divider, so I cut out an opening for it.

Yes, it will have a bump where the flow divider is located, but it won't be much of a bump.

Previous Day | HOME | Next Day